International CabOver
#1
Rookie
Thread Starter
Join Date: Jul 2010
Posts: 3
International CabOver
I have a cummins engine and when I am under a trailer I lose power going up hills and now it will only run 66 miles an hour. The speedometer is not working now when it once was. Any ideas what is wrong?
#4
It could be any number of things.
Bad Ground on the Speedo head or a bad speedo head. Broken wire. Bad sender at the Transmission.
__________________
Colt: The original point and click interface. Gun Control isn't about guns, It's about Control.
#5
If the Cummins is an electronically controlled engine, then I would suspect a problem with the VSS (vehicle speed sensor) or it's associated wiring.
A problem with the VSS will cause the ECM to go into "limp mode" (HP derate) and will also cause the speedo to quit working, as there is no vehicle speed data being sent to the ECM. The VSS is located at the transmission tailshaft, right where the old type speedometer cable would have been if it was a mechanical type setup. .
__________________
If you can't shift it smoothly, you shouldn't be driving it. |
|